Torque spanner used to screw big high-tension hexagonal bolt and testing should be receive torque adjusting before and after application.
高强度大六角头螺栓施拧采用扭矩扳手和检查采用的扭矩扳手在班前和班后均应进行扭矩校正。
Install high-tension bolt after check and accept of structural center`s position.
结构中心位置经调整检查无误后，即安装高强度螺栓。
When H-shape is widely applied in the framed column, there is no rule for design of column flange backing in the case that the thickness of the end plate, which is given by the tension of the bolt, is larger than the thickness of the column flange which the beam is connected to, while the column section can not be changed.
在H型钢普遍应用于框架柱时，当根据螺栓所承受的拉力计算出的梁端板厚度比与其连接的柱翼缘部分的厚度大时，且无法更改柱截面的情况下，柱翼缘部分的补强设计无据可依。
If thread is damaged, burr should be cleared after amendment. Remove high-tension bolt after the high-tension bolts` fastness.
如螺纹损伤，修孔后清理毛刺，高强度螺栓紧固后，即拆下临时螺栓。
Multi-stage pump stator by the inhalation of some of the main paragraph, middle paragraph and out, such as guide vane component, there will be tension bolt clamping paragraphs constitute studio.
多级泵定子部分主要由吸入段、中段、吐出段和导叶等组成，有拉紧螺栓将各段夹紧，构成工作室。
This is necessary to assure that the minimum anchor bolt tension is achieved.
需要确保达到最小固定螺栓张力。
THE METHOD OF DOUBLE-SUBSTRUCTURE IN THE STRESS ANALYSIS OF BOLT SCREW WITH INTERFERENCE FITTING Direct Testing of the Pre-tension in Screw Connection
用二次子结构法对过盈螺纹进行应力分析
The strengthened method using profile steel and prestressed bolt means that concrete beam is strengthened around its section by bonding profile steel and prestress is applied by high-tension bolt, which is a new advanced strengthening technique.
预应力包钢法是在混凝土构件四周包以型钢，采用高强螺栓对外包钢施加双向水平预应力的一种先进的加固新技术。
Firstly, this paper does theoretical research when tension acts on the bolt tip, and derives the distribution law of the bolt shear stress and axial force, and defines three different bolt stress state.
首先，本文对锚杆端部受拉力时做了理论研究，推导出锚杆剪应力与轴力的分布规律，并定义了锚杆三种不同的受力状态。
Ultrasonic measurement of high strength bolt axial tension in steel construction
钢结构工程中高强度螺栓轴向应力的超声测量技术
Install high-tension bolt after check and accept of structural center's position.
结构中心位置经调整检查无误后，即安装高强度螺栓。
The quality guaranty at connections with high tension connecting bolt in Xupu Bridge
徐浦大桥高强螺栓连接质量保证
The model of the aluminum alloy wheel classified as 16 x 6.57 is built. Static stress analysis is carried out to study the influence of bolt pre-tension, centrifugal force and the cornering force to the structural as well as the distributing rule of stress and strain.
首先根据试验工况建立起16×6.5J车轮的有限元模型，通过静力分析研究螺栓预紧力、旋转离心力和试验弯矩对车轮结构强度的影响以及车轮结构的应力应变分布规律。
As the bolt tension increase, the tension of rail web, stress of joint bar and stress of joint bolt would increase accordingly, but the displacement of rail would become smaller.
螺栓扭矩增大，接头区钢轨轨腰拉力、夹板应力、螺杆内应力都会增大，而钢轨位移会随着螺栓扭矩的增大而减小。
A knot was tied in the medial part of the tendons and one bone lock bolt of 12 mm × 6 mm was inserted after preliminary tension of semitendinosus and gracilis tendons.
半腱肌腱和股薄肌腱预张力后，肌腱中间打结嵌入12mm×6mm骨栓。
The paper analyzed the bolt pre-stress affected to the mine roadway support effect and the relevant relationship between the bolt pre-tightening torque and the pre-tension.
分析了锚杆预应力对巷道支护效果的影响，锚杆预紧扭矩与预紧力对应关系。
A mechanics model of dynamometry bolt was given and it was shown that dynamometry bolt mainly bear tension and torque in real application.
给出巷道支护中测力锚杆的力学模型，指出测力锚杆实际应用中主要承受拉力、扭矩作用。
Effect of End-plate to End - plate CFT - H Connection and Calculate Method of Bolt Tension
端板厚度对钢管混凝土端板梁柱节点的影响及螺栓力计算方法
Via on an instance, it is proved the influence and importance of the thickness adoption of end plate in design of the bolt-together joints for tension, bending and shearing resistance.
通过实例进行计算，说明撬力在抗拉弯剪螺栓节点设计中对端板厚度取值的影响和意义。
The brittle failure of hign strength joint bolt on a ladle turntable happens often under the static load and low stress due to the sensitive and sudden break-up of cracks in hign tension alloy steel.
本文介绍了钢包回转台高强度连接螺栓在静载低应力状态下脆断的实例，证实了断裂原因是由于高强度合金钢裂纹敏感型突发性脆断所致。