The Stacker-reclaimer system has the tanglesome steel frame structure, therefore the guarantee the anti- pulled and anti- pressed intensity of the structure and the equipment distortion is precondition to improve on the structure of the equipment.
堆取料机系统具有结构复杂、旋转半径大的大型钢架结构设备，因此保证结构的抗拉压强度和设备整体绕度是改进设备的结构性能的前提。
Steel strings are twanged while being pressed with a movable steel bar for a glissando effect.
当被滑动法演奏的可移动钢管施压时能够发出弦声的钢弦。
The valve body is made from carbon steel or seamless stainless steel pipe by pressed forming
阀体采用碳钢或不锈钢无缝管压制成形。
Now composite brake-shoe material was prepared, taking modified PF resin as matrix, mild-steel F-fiber as reinforcing agent, barium sulfate, graphite and bauxite chamotte etc as filler, by hot-pressed method in 10.5～11.5MPa pressure and at different temperature.
以改性酚醛树脂作为基体原料，分别用低碳钢F型纤维做补强剂，硫酸钡、石墨和高铝矾土等做填料，在10.5~11.5MPa的压力下采用不同温度热压制方法制备出了新型高摩合成闸瓦材料。
The tower is 221.75 M in height （12.8 M underground and 208.95 M on the ground ）. It ` s conical-tube from the ground ±0.00 to 46.5 M ground elevation （24M in lower diameter and 18M in upper diameter ）. Above the height of 46.5 M is straight tube tower body with the diameter of 18M; the thickness of reinforced concrete structure tube wall is 350-650 M M; the tower is equipped with two elevators （ one is built in and the other is for external view ）; the tower is equipped with nine steel-reinforced concrete platforms, the elevations are 32.5 M, 46.5 M, 76.5 M, 106.5 M, 136.5 M, 166.5 M, 196.5 M, 203 M and 207.7 M respectively. Steel platform was connected by I-steel beams and refined high-friction bolts and installed into grid upper pressed steel plates as casting reinforced concrete floor.
此塔身总高221.75 M （埋深12.8 M ，地上208.95 M ），自地面±0.00至标高46.5 M 为圆锥筒体（下口直径24 M ，上口直径18 M ）、46.5 M 以上为直径18 M 直圆筒塔身；钢筋砼结构筒壁厚350-650 M M ；塔筒设两部电梯塔体内设9层钢—钢筋砼平台，标高分别为32.5 M、46.5 M、76.5 M、106.5 M、136.5 M、166.5 M、196.5 M、203 M、207.7 M ；钢结构平台采用工字形钢梁并用精制高强摩擦螺栓连接、组装形成方格网上铺压型钢板作为底模浇注钢筋砼楼面。
The grapes skin must be submergedtwo times a day to prevent the oxidation and mass temperature became low, less 36 degree, it can block off the fermentation. After 5-7 days take the wine by steel box and the skin grapes which have the liquid must be pressed again, all the wine filled in the steel box. After 20 days need to do the 1° siphon off, take wine sample and checked his acidity. After three months the wine must be siphon off in French oak for 10-15 months and after in the bottle for minimum 3 minutes
葡萄表皮必须一天两次浸渍在葡萄汁避免氧化和质量温控低于36度，它能控制发酵的速度，5到7天以后，用不锈钢的罐子榨压过滤，然后把葡萄酒倒入不锈钢罐子。20天之后，第一次需要虹吸方式吸出些酒样，检测其酸度。3个月后葡萄酒必须同样以虹吸的方法到法国橡木桶，放置10到15个月，之后，罐装到瓶子，至少3个月的时间。
By coating pressed self-propagating high-temperature synthesispowder on the wear resistant surface part of evaporative pattern, the powder can be lit up automatically through touring high temperature molten steel and can form reinforce phase of ceramics.
在消失模铸造过程中，将合金粉末涂抹于模样表面，利用高温液体将其熔化并铸渗到铸件表面，可使铸件获得优异的表面性能，此工艺成本低廉、简单易行，得到越来越多科研工作者的重视[1-3]。
H- section steel in the Section Steel Plant, rough rolled, directly enters the finishing mill train, causing some parts in the surface pressed in by reoxidation rolling scale, influencing the appearance of the steel.
型钢厂中型线的H型钢经粗轧后，直接进入精轧机组，造成表面部分二次氧化铁皮压入，影响了钢材的外观形象。
On the basis of investigations on the usage of PHC spun piles at wharves and piers at middle and lower reaches of Yangzi river and Shanghai coastal areas, the author has introduced the general production procedure of spun pile and points for attention, interpreted the importance and necessity of develop of PHC spun pile with large diameter and length, discussed some key technique on manufacturing of PHC spun pile with large diameter and length, eg, the design of steel mould with pressed-pole stability calculation, research and production of spinning machine, selection of lifting equipment and hooks, pre-stress loss calculation, temperature control of autoclave curing, etc.
文章调研了长江中下游和上海沿海地区的港口码头使用大直径PHC管桩的情况，讲解了PHC管桩生产的一般程序和注意事项，论述了开发大直径超长PHC管桩的重要性和必要性，同时对超长大直径PHC管桩生产的核心技术进行专门研究和解决，如：钢模的压杆稳定设计、离心机的研制、起重设备及吊具的选用、预应力损失计算、高压蒸养的温控等等。
Fuel oil pipe, Lube oil pipe, sea water cooling pipe, fresh water cooling pipe, exhaust pipe, air compression pipe are tested in the workshop and are pressed steel stamp, and are tested the tightness after installation.
b 燃油，滑油，海水冷却、淡水冷却，排烟，压缩空气管系在车间的液压试验和打钢印及安装上船后的密性检查。
The furnace shell is pressed forming by cold-rolled steel and section steel special mold, Lining adopts energy-saving super-long fiber silicate insulation superfine cotton fiber which has warming rapidly, insulation, and temperature uniformity, energy-saving advantages. Heating components use far infra-red plate or tubular heating elements that can be easily replaced, .It is not easily damaged, with longer life expectancy.
炉壳由冷轧钢板和型钢专用模具压制成形，炉衬采用节能型超保温超细长纤维硅酸铝纤维棉，具有升温快，保温好，温度均匀，节电等优点，发热元件采用可拆换式远红外线板状或管状发热元件，不易损坏，使用寿命长。
Silicon steel sheet pile pressed and riveting magnetic pole is applied, thus mechanical characteristic is improved.
同时采用了硅钢片叠压铆接磁极，提高了产品的机械性能。
Specializing in the production van, box-type filter press, type specifications from 320-2000; filter area from 0.5m2-800m2; frame materials have cast iron, reinforced polypropylene, glass fiber reinforced polypropylene, rubber and stainless steel, etc.; compact form have manually pressed, mechanical compactor, automatic hydraulic pressure and advanced full-automatic PLC programming, such as automatic drawing board; filter has prescribed the form of streams, undercurrent undercurrent can be washed out and two-way cross-washing.
专业生产厢式、框式压滤机，规格从320-2000型；过滤面积从0.5m2-800m2；板框材质有铸铁、增强聚丙烯、玻纤增强聚丙烯、橡胶及不锈钢等；压紧形式有手动压紧、机械压紧、液压自动保压及先进的全自动PLC编程自动拉板等；过滤形式有明流、暗流、明暗流可洗和双向交叉洗涤。
It swung into view deliberately, swept past with a powerful swaying motion of the engine, a low smooth rumble of his heavy cars upon pressed steel, and then it vanished in the cut.
他的这些特点在《四月，四月杪》这个短篇中也有所反映。
The shied is made by phosphatizing steel skeleton and butyronitrile rubber with hot pressed.
NIN轴承套圈和钢球采用精炼轴承钢GCr15(AISI 52100)制造，保持架采用黄铜带（H62）或优质冷轧钢带(SPCC BQB402)冲压制成，必要时可用增强工程塑料制造，防尘盖采用进口专用材(SP CCJISG314)或不锈钢带(1Cr18Ni9)制成，密封圈采用磷化钢骨架和丁腈耐油橡胶热压制成。
Special partitions, for use in toilets etc., are often made of pressed steel, plastics, asbestos cement, tile s or glass.
用于盥洗室等处的专用隔墙，通常采用冷弯压制的钢板、塑料板、石棉板、壁砖或玻璃板等构成。
Then one of the bank workers pressed a button behind the counter and the steel gate at the front of the bank moved into place so that we were locked in.
接着一个银行职员按下了柜台后面的按钮，银行前面的保险门便自动合上，把我们锁在了里面。
Constructed of pressed steel and stainless steel, this sturdy and attractive fire pit is built to last.
压制钢 ，不锈钢，这个坚固的和有吸引力的火坑人工构建的最后。
Constructed of pressed steel and stainless steel, this sturdy and attractive fire pit is built to last a lifetime.
压制钢 ，不锈钢，这个坚固的和有吸引力的火坑人工建造的，是持续一生。
We are in need of forged rings, turned rings, steel pressed cages, brass solid cages, balls, rollers (spherical, cylindrical, tapered rollers), rivets, shields, seals and You are kindly requested to inform us about your products and send your working schedule for the items in your sphere of interest.
我们需要锻造的吊环，扭转吊环，钢铁压笼，铜管实心的笼子，球，滚轴(球状的，圆柱的，圆锥滚子)，铆钉，盾牌，印章。并恳请你告诉我们你们的产品和发送你们的工作日程中感兴趣的项目领域。