A new radial friction welding band technology on small shell was proposed.
介绍了小口径炮弹弹带的摩擦焊技术。
A first step, his thumb and index finger hook rubber band, when the index finger and middle finger to maintain a state of closure, in the friction of the rubber band when the two cross-cutting, with the middle finger caught rubber band, releasing the index finger and then the index finger
第一步，拇指和食指钩住皮筋，此时食指与中指保持合拢的状态，在摩擦两个交叉的皮筋时，用中指挂住皮筋，松开食指，然后再用食指钩住皮筋，这样皮筋就出来了。
The 3D-model of the brake band, countersunk head bolt and Friction Flake is established, and the frictional contact problem of brake band and friction flake was analyzed with the large-scale nonlinear finite element analysis software MSC.
以某超级油轮的锚机带式制动器为研究对象，建立了制动带、沉头螺钉和摩擦片的三维实体模型，并应用大型非线性有限元分析软件MSC。
When you press on the foot brake, friction band s push hard against the wheel drums and stop the wheels from turning.
当你踩下脚制动时，摩擦片就会紧紧地压在车轮制动鼓上，使车轮停止转动。
During operation, never grip both the hoisting and lowering band brakes, also never use the hoisting band brake and also the control lever of friction-clutch at the same time, otherwise it might cause severe accident.
在操作过程中，绝对禁止将提升抱闸和下降抱闸同时刹住，禁止提升抱闸与摩擦离合器操纵手把同时使用，否则将产生严重的机械事故。1。
Precision band rolling; the Boundary Element Method; the elasto- plasticity contact with friction; existence and uniqueness of the solution; condensation matrix algorithm; network parallel algorithm
高等学校博士学科点专项科研基金；河北省自然科学基金精密板带轧制；边界元法；弹塑性摩擦接触；解的存在唯一性；凝缩矩阵算法；网络并行算法
Quantitative analysis of energy transform is carried on to estimate the energy dissipated due to particle colliding with the primary system and each other. It is found that the energy dissipation in collision is of the same order as that of friction. NOPD has a wider vibration-reducing frequency band. Generally, dissipation due to friction exceeds that of collision.
通过对微颗粒组合体与主结构相互耦合运动的计算机仿真，对微颗粒组合体与主结构之间能量传递及其运动过程中的能量损耗的定量计算分析，得到了NOPD阻尼机理的一般性结论：NOPD的摩擦耗能与冲击耗能具有相同数量级的阻尼效应，但微颗粒粒径越小，摩擦耗能就越明显大于冲击耗能；NOPD具有较宽的减振频带。
Numerical simulation on the frictional contact problems of brake band-friction flake;
讨论了弹性波在压电介质摩擦接触界面上的反射和透射问题。
The controller is used in velocity mode or torque mode flywheel, as a result the effect of friction torque is greatly suppressed especially in low velocity band, and the dynamic performance and static accuracy of flywheel torque/velocity output are met in full velocity range.
该控制器应用于速率模式和力矩模式的飞轮，有效克服了低速非线性摩擦干扰，使飞轮的速率/力矩在全速度工作范围内的动态性能得到有效保证。
The stress and the friction coefficient of band during the engraving process were researched, and the resistance of this special structure was calculated. The influence of the engraving process on the interior ballistic performance was also analyzed.
研究了埋头弹火炮弹带挤进时的流动应力和摩擦系数，针对其特殊结构数值计算了挤进阻力，分析了挤进过程对内弹道性能的影响。
Also, Influence of different performance parameters of friction disc on the distribution law is discussed. This provides a reference for optimal design of band brake.
分析了摩擦片不同性能参数对温度场分布规律的影响，为带式制动器的优化设计提供参考。
This paper describes the first attempt to utilize a dynamic friction component model in drivetrain simulations. Specifically, a dynamic band brake model is implemented to predict the up shift behaviour of a four speed AT system under various operating conditions.
本文阐述首先试图在传动系仿真中利用一个动态摩擦组件模型，特别补充用一个动态带制动模型予示一个4档AT装置在不同工况下的换升档动作。
Frication coefficient of non-asbestos woven brake band made with this binary-modified phenolic resin was above 0.50 at low temperature and was above 0.40 at high temperature. The recovery of friction coefficient was well too.
用该双改性树脂作为基体树脂制备的无石棉编织型制动带，低温摩擦系数达050以上，高温摩擦系数可达040以上，且摩擦系数恢复性良好。
Diamond is a remarkable material due to its special crystal structure, which shows high hardness, low friction coefficient, high thermal conductivity, high optical transparency, low permittivity and high band gap etc.
金刚石的特殊晶体结构使其成为一种性能优异的功能材料，它具有高硬度、低摩擦系数、高热导率、高透光率、低介电系数和高禁带宽度等性质。
Diamond has many characters, such as high thermal, low permittivity, high band gap, super high hardness, low friction etc, which makes it possible to be widely used in industry.
金刚石具有高导热率、低介电系数、高禁带宽度、超高硬度、低摩擦系数等性质，在国民经济的许多部门得到了广泛的应用。
Influences of initial cohesions and friction angles on shear band (SB) patterns and entire deformational characteristics were investigated.
目的研究初始内聚力及摩擦角对剪切带图案及岩样全部变形特征的影响。
Instruction: friction band is installed between vacuum box and adhesive belt with airproofing, lubrication and cooling to lessen resistance to adhesive belt.
摩擦带是安装在真空盒与胶带之间，并以水密封、润滑、冷却，减少胶带运行的阻力。
Analyzed the stress situation of the cavity die inwall in the deformation process detailed, and knew how the deformation band, friction condition, deformation degree and deformation material influence the cavity die inwall lateral pressure through changing deformation condition.
详细的分析了变形过程中冲孔模内壁的受力情况，并且通过改变变形条件的方法分别得出了变形区域、摩擦条件、变形程度及变形材料等参数对冲孔模内壁压力的影响。
The strenuous flowing band following the friction stir welding tool was the position of formatting tunnel hole in the welding joint.
搅拌头后端材料的剧烈流动带，是搅拌摩擦焊焊缝形成隧道孔的主要原因和位置。
Study on Radial Friction Welding Band of Small Shell
弹带熔敷扩散焊接技术研究小口径炮弹弹带摩擦焊技术