Meanwhile, an integrated comparator with complementary open-collector outputs can be used to create PWM control loops, or provide simple logic of, for example, an over-power pin, an LED indicator alarm, a MOSFET load cutoff switch, an external fan, or a binary counter for metering applications.
同时，内建具备互补开路集极输出的比较器可用来建立 PWM控制回路，或提供如过功率针脚、LED指示灯警示器、MOSFET负载开关、外部风扇的简单逻辑，或二进制计数器以供电表应用。
The drum body is fixed horizontally on three points. Through the special spiral mouth, it can load and unload skins, add water and materials, take inspections etc. There are drainage, water collector and transmission system at the back of drum.
结构特点：整机鼓体无升降三点式水平放置使用，是靠独特螺旋鼓口来完成装皮、卸皮、加水、加料、取样等，后置排水阀、集水槽、链轮减速传动系统，可实现洗皮、换水及分流排放，整体内外玻璃钢防腐。
This paper has analysed the waveforms of Class E amplifier with shunt inductor. The value of the collector current and voltage, the output power, and the parameters of the load network are also determined, which provide reference basis for the design of the amplifier.
本文对带旁路电感的E类放大器的波形、集电极电流和电压、输出功率进行了分析，计算出负载网络的最佳参数，为该类放大器的设计提供了依据。
Under the state of optimum operation of the amplifier, the following basic amplifier parameters are determined: the waveforms of the collector current, the collector-to-emitter voltage, the instantaneous power dissipated in the transistor, the collector efficiency, and the values of the load-network components.
在最佳工作状态下，确定了放大器的集电极电流和集电极-发射极电压波形、晶体管的瞬间能量损失、集电极效率和负载网络参数。
Voltage Source and Current Source, Thevenin Theory, Trouble Shooting, Characteristic Curve of Diode, Diode Models, Rectifier Circuits, Input Filtering Capacitor, Voltage Multiplier Circuits, Limiter and Clipper Circuits, DC Clampers and Peak-to-peak Detectors, Zener Diode, Zener Diode Rectifier, Photoelectric Devices, Collector-Emitter Junction, Transistor Characteristics of common-emitter, Base Bias, LED Dirver, Establishing a Stable Q-point, PNP Transistor Biasing, Transistor Biasing, Coupling and By-Pass Capacitors, AC Emitter Resistance, Common-Emitter Amplifier, Other Common-Emitter Amplifiers, Cascaded Common-Emitter Amplifiers, AC Load Line, Emitter Follower, Class B Push-pull Amplifiers, JFET Characteristic Curve, JFET Biasing, JFET Amplifier, VMOS Circuit, Differential Amplifier, Operational Amplifier, Non-inverting Feedback, Negative Feedback.
电子学实验(S0704)(1，1)/应用电子学实验(S0472)(1，1)电压源和电流源、戴维宁定理、故障排除、二极体特性曲线、二极体近似模型、整流电路、电容-输入型滤波器、倍压电路、限制器电路和峰值检测电路、直流定位器与峰对峰检测器、齐纳二极体、齐纳二极体整流器、光电元件、集射极接面、集极特性曲线、基极偏压、LED驱动器、建立一个稳定的工作点 Q、PNP 电晶体偏压、电晶体偏压、耦合及旁路电容、交流射极电阻、共射极放大器、其他 CE 放大器、串接共射极放大器、交流负载线、射极随耦器、B 类推挽式放大器、JFET 特性曲线、JFET 偏压、JFET 放大器、VMOS 电路、差动放大器、运算放大器、非反向电压回授、负回授。
Then the cyclone collector was added, the running load of fan was adjusted and part structure was improved, which made the smoke dust discharge concentration fall to the third class of national discharge standard.
通过增加旋风除尘装置、调整风机运行负荷、改进局部结构等，使外排指标均达到三级排放标准。
Now that you are logging information from the garbage collector, run your application under normal load.
启用垃圾收集器的日志记录之后，在正常负载下运行应用程序。
The results indicate that the energy collected by smaller solar collectors could be sufficient for the heat load of a building when the collector area and the storage volume are optimally matched.
结果表明，当太阳能集热器面积与蓄热体积匹配合适时，使用较小面积的太阳能集热器集得的热量就可满足建筑物的热负荷需求。
Features exceptional tolerance to base drive and collector current load variations resulting in a very low worst case dissipation.
特殊功能的驱动器和耐基地集电极电流负载的变化在一个非常低的损耗造成的最坏情况。
The correlation between the heating load of building and the solar heat collection of solar collector system was analyzed in the climate region of Xining, the capital of Qinghai province in Chino.
结合西宁地区的气象资料，计算太阳能系统集热量与建筑热负荷之间的相对关系；
Method throws an IOException, then the stream will not be closed (until the garbage collector runs its finalizer).
但是如果props.load（）方法抛出一个IOException，那么流则不会被关闭（直到垃圾收集器运行其终结器）。
The this design basis related standard, in the consideration energy conservation and under the comfortable request's premise, the refrigeration engine room supposes in underground one, selected has opened the advantage factory piston cold water unit, in the refrigeration engine room establishes the circulating water pump, the supplies water pump, to divide the water collector, the zeolite softener and so on supporting facility; The air-conditioning system uses the air blower serpentined to add the new atmosphere system, each has the corresponding new atmosphere unit, the indoor load mainly undertakes by the air blower serpentined.
本设计依据有关规范，在考虑节能和舒适性要求的前提下，制冷机房设于地下一层，选取了开利厂家活塞冷水机组，制冷机房内设置了循环水泵、补给水泵、分集水器、软水器等辅助设备；空调系统采用风机盘管加新风系统，每层都有相应的新风机组，室内负荷主要由风机盘管承担。
Secondly, we establish transient mathematical model of fluids (usually, it is composed of motion equation, continuity equation and energy equation) based on flow behavior in pipeline and load it to the emulation analyses module. After that we take simulation results of steady-state model as initial condition and solve the model using characteristics method, so as to forecast hydraulic performance and equipment running status at all time and each detection point, meanwhile, show it as chart through computer. And then, we compare the pipeline theoretical working parameters including temperature, flow and pressure which are obtained through computer simulation to the real data which are collected by data collector attached to pipeline, if the difference exceeds scheduled threshold value which is the minimal leakage detected by system, then leakage take place.
其次，通过流体在管道内的流动特性，建立了管道内流体的瞬变数学模型(液体管段瞬态流动的数学模型一般是由运动方程、连续性方程和能量方程组成)，并将其存放到仿真软件的仿真分析模块中，将稳态模型的模拟结果作为初值条件，利用特征线法对瞬变数学模型进行求解，从而预测管道在预期工况下任何时刻、各个检测点的水力特性及设备运行状态，同时通过图表显示在计算机上，然后将通过计算机模拟，得到的管道理论运行参数，与安装在管道上的数据采集仪器采集到的实际数据相比较，如果两者的差值超过了预定的限值，则可判断管道发生泄漏。