Of Yangquan City was built in 1957, enterprises are equipped with 4 sets of milling machines, 4 sets of wet-sanding machine, Enamel Reactor 6, stainless steel reactor 7, a set of phosphorus trichloride production plant.
阳泉市璜粉有限公司建于1957年，企业装备有4台磨粉机，4台湿式砂磨机，搪瓷反应釜6个，不锈钢反应釜7个，一套三氯化磷生产装置。
C. In the meantime, by using wet-milling, in the short duration of balling, sintered Ti substrate comprise an encircled and connected net in which HAP is homogenously dispersed. This composite has not only bearing high loads properties, but also excellent bioactivity. Ti/HAP is one of ideal bioactive materials.
同时，采用湿磨工艺，经较短的球磨时间后，即可在烧结后Ti基体组成了连通的网络，HAP相则均匀弥散分布于其中，这种结构可使Ti基体在承受载荷的同时还能保持好的生物活性，是一种较理想的生物医用活性材料。
Using a variety of techniques and materials piano paint, water mill, paste wood leather, acrylic, iron, stainless steel wet milling polishing, strengthened glass, special glass, aluminum panels, fire-proof panels, etc.
采用多种工艺和材料（烤漆、免漆、油漆、水磨、贴实木皮、亚克力、铁艺、不锈钢水磨抛光、玻璃钢、特种玻璃、铝塑板、防火板等）能够制作各类型展柜，尤以精品展柜擅长。
The physical and chemical properties and strength of fly ash treated by wet milling are studied.
因研磨效率较高，采用搅拌磨对矿物掺合料进行湿磨处理，制备了一种浆状掺合料，主要探讨湿磨对粉煤灰物化性能及胶砂强度的影响。
Steeping is one of key steps of wet milling process, steeping affects starch yield and quality.
浸泡是玉米淀粉湿法加工工艺的一个重要环节，玉米浸泡的质量，直接影响到后道工序的正常生产，影响淀粉生产的得率、质量和产量。
Based on analysis state of utilization of wet discharge calcium carbide sludge in cement clinker production and experimental study of the dewater properties of calcium carbide sludge, new dry milling and dry firing process, mechanical dewatering-use vertical mill to dry and grind proportioned mix-use pre.
在充分分析利用湿排电石渣生产水泥熟料的现状和对电石渣脱水性能的试验研究基础上，采用了湿排电石渣的机械脱水处理→配料后用立磨烘干粉磨→采用窑外分解技术进行熟料煅烧的新型干磨干烧工艺，生产出优质高标号水泥。
This luxury large house building land 20 acres or so, the construction materials used must be carefully selected by artificial wet milling, engraving, inlay made, all the doors, floor, Pavilion, Liang, Ping are engraved landscapes, flowers, birds, dragon and phoenix, characters, etc.
这一豪宅大屋建筑用地20亩左右，建筑所用材料必须精挑细选，经人工水磨、雕刻、镶嵌而成，所有门、楼、阁、梁、屏均刻有山水、花鸟、龙凤、人物等浮雕，栩栩如生，惟妙惟肖，结构严谨得体，整座建筑充分体现清初客家人建筑艺术与风格。
It is thus clear that, the adoption wet method ball-milling to makethe flake of aluminum powder pigment is completely viable.
可见，采用湿法球磨制备漂浮型片状铝粉是完全可行的。
The mainly conclusions in our research are as flowing: tungsten trioxide powders with 100 nm primary particle are obtained by spray drying, calcination and wet milling process, and an average size of quadric particle composed of agglomerated particles is 0.64 μm; tungtsen powders with 39 nm grain size and 60 -100 nm primary particle are produced directly from previous tungsten trioxide using one step reduction in hydrogen at 700℃, and an average size of quadric particle of tungsten powder is 2.91 μm; tungsten trioxide and copper tungstate compound powders with 100 nm - 200 nm primary particle are produced using ammonia metatungsten and copper nitrate as raw materials by spray drying, calcination and wet milling process; the compound powders are transformed completely into tungsten and copper compound powders by reduction in hydrogen at 700℃, in which tungsten grain size is 59 nm and copper grain size is 51 nm; primary particle size of compound powders is 80 - 120 nm, and an average size of agglomerated quadric particle is 1.86 μm; tungsten nitride powders with 35 nm grain size are prepared from tungsten trioxide powders by nitrogen treatment thoroughly in pure ammonia at 650℃, and an average size of agglomerated quadric particle is 0.64 μm in normal temperature.
研究结果表明：采用喷雾干燥—焙烧—球磨工艺可以制备出粒度约为100nm的WO_3粉体，它们在团聚后形成的二次颗粒平均粒度为0.64μm；采用一步直接氢还原方法可在700℃下从上述WO_3粉体制备出晶粒尺寸为39nm的、一次颗粒粒度为60-100nm的W粉体，其二次颗粒的平均粒度为2.91μm；以偏钨酸铵、硝酸铜为原料，采用喷雾干燥—焙烧—球磨工艺可制备出一次粒度为100-200nm的WO_3和CuWO_4混合粉体；采用氢还原工艺可在700℃下将这种粉体完全转变为W、Cu复合粉体，其中W的平均晶粒粒尺寸为59nm，Cu的平均晶粒尺寸为51nm；复合粉体的一次颗粒尺寸为80-120nm，在常温下团聚后形成的二次平均粒度为1.86μm；采用纯氨氮化工艺可以在650℃下由WO_3粉体制得WN，其晶粒尺度为35nm，在常温下团聚后的二次平均粒度为6.4μm。
Study on the mechanism of improving gas forming and thickening properties of aerated concrete slurry by applying wet blend-milling technique
湿混磨工艺改善料浆发气稠化特性的机理研究
In this paper, a wet solid phase mechanochemical method was used to synthesize the precursor of rare earth aluminate blue emitting phosphor. The phase evolution during milling and annealing process were examined by using XRD and DTA TG analysis technology.
采用湿固相机械化学法制备稀土铝酸盐蓝色荧光粉前驱体，用XRD和DTATG分析技术研究了湿固相球磨过程和后续煅烧过程中的物相转变。
Various products can be obtained such as corn starch, corn oil, dextrins, corn syrup, high fructose corn syrup, corn oil meal, dextrose and corn gluten can be developed after wet milling.
湿磨加工后进一步开发可以得到玉米淀粉、玉米油、糊精、玉米糖浆、玉米高果糖糖浆，玉米油渣、右旋葡萄糖和玉米麸质片。
Starches and proteins were extracted and separated from small red bean, large red bean and scarlet runner bean by wet milling method. Physicochemical properties of starches and proteins as well as the differences between them have been studied systemically. 1.
本文选取小红豆、大红豆和荷包豆三种豆类作为原料，通过水磨法提取分离其淀粉及蛋白质，系统研究了淀粉和和蛋白质的各种理化性质及差异。
Election and analysis of bearing of inclinable wet milling machine
可倾式湿磨机轴承的选用及分析
The series of ball mill is suitable for large architectural ceramic, sanitary porcelain, electric porcelain, metallurgy and chemical industry as milling wet grind materials equipment.
本系列球磨机主要用于大型建筑陶瓷、日用陶瓷、卫生陶瓷、电瓷、冶金、化工等行业作为湿法研磨物料用的一种大型球磨设备。
Steel slag mud is a byproduct generated after the wet ball milling and magnetic separation of BOF slag, whose hydraulic cementitious property is relatively poor.
钢渣尾泥是转炉钢渣经湿法球磨、磁选处理后的副产品，其水硬胶凝活性较低。
The Application of Wet Milling Converter Slag in Cement Production
湿式球磨转炉废渣在水泥生产中的应用实践
The waxy corn flour by dry-milling exhibited good digestibility and solubility, while that by wet-milling method had strongly swelling, high transparency, good freezing a.
本文分析了干法制粉与湿法制粉获得的蜡质玉米粉与糯米粉的性质差异。
The application prospects of membrane technology for steep water concentration, treatment of evaporating water overhead, corn oil processing, protein separation, starch washing, dewatering and concentration in cron wet milling industry are emphatically introduced.
重点介绍了薄膜分离技术在浸渍液浓缩，蒸发器顶流出物处理、玉米胚芽油加工、玉米蛋白质分离及玉米淀粉洗涤、脱水和浓缩等玉米湿磨工艺中的应用前景。
Corn starch was produced by wet-milling technology from germinated black waxy corn.
将黑糯玉米进行发芽处理后，采用湿法提取工艺制得淀粉。