On this basis, in accordance with the requirements of drying capacity per hour, the volume of the drying chamber, motor, pulley, etc. Calculation of the design.
在此基础上，根据每小时干燥量的要求，对干燥室的容积、电动机、皮带轮等进行了设计计算。
In this article a calculation formula for fiber volume fraction of hybrid fibers was deduced, four linear was designed though changed the hybrid ratio and the tensile properties was studied.
本文探索了混杂纤维复合材料体积含量的计算方法，通过改变混杂比设计了四种线型并对复合材料拉伸性能进行研究，观察断口形貌，分析其断裂机理。
Adsorption process could be divided into three to four stages with relative pressure of ca. 10〓～10〓, 10〓～10〓, 10〓～10〓, and 0.9～1. These were attributed to different pore filling with pore size changing. Activated diffusion was discussed in detail and in evidence by theory calculation. The micropore volume and the external surface area were assessed by the high-resolution α〓 plot method. It was shown that the adsorption filling process for samples activated by different methods with the increasing of activation degree was quite different. For steam-activated series of samples, the pore filling with the increasing of activation degree changed from micropore filling to mesopore filling until macropore filling at relative pressure closing to unity. For air-activated series samples, all samples showed mainly ultramicropore filling. For KOH-activated series samples, the samples showed mainly ultramicropore and supermicropore filling, and supermicropore filling was dominant.
本文还详细地讨论了活性扩散过程，同时也计算了平均孔径尺寸；由α〓图对所研究样品的表面积、外表面积以及吸附类型进行了考察；结果表明对于由不同活化方法所制备的样品，随着活化程度的变化，其吸附填充类型有较大差别：对于水蒸气活化样品随着活化程度的增加，其填充由主要以微孔填充渐变为毛细凝聚的中孔填充直至表现出大孔填充；对于空气活化系列样品则主要表现为狭小微孔（极微孔-Ultramicropores）填充；对于KOH活化系列的样品主要表现为以较大微孔（超微孔-Supermicropores）的填充。
In addition, the important forms used to calculate the formation parameter s, such as shale volume, water saturation and permeability, are improved to be more suitable for the calculation of inhomogeneous formation parameter s according to the power law of fract.
同时，利用分形理论的幂定律，对泥质含量、含水饱和度和渗透率等参数的计算公式作了改进，可以更好地适应非均质地层参数的计算。
According to the design characteristics of buildings, as well as strictly accurate load calculation, according to the calculation of cooling load and the volume of outdoor air system for its wind and water piping system to carry out an economic and rational arrangement in detail of the diameter of the marked as well as the elevation of the pipeline.
本设计根据建筑物的特点进行了严格以及精确的负荷计算，根据计算的冷负荷和新风量对其风系统和水系统中的管路进行了经济、合理的布置，详细的标出了管径以及其管路的标高。
Based on the trational calculation method of the wind exhaust volume calculation, a more reasonable c.
通过对粘胶纤维厂酸站储罐设备内有害气体逸出储罐机理的分析，讨论了局部排风控制有害气体不逸出储罐的原理，指出目前采用的酸站储罐内排风量计算方法的不合理性。
In this article, the author compares and analyzes three kind of main calculation formulas of the square grid quadrilateral prismoid field leveling earth volume, and provides a formula to calculate directly total excavation and filling earth volume according to construction altitudes of angular points of square grids.
对场地平整土方量方格网四方棱柱体法的3类主要计算公式进行了对比分析，提出了根据方格角点施工高度直接计算场地总挖、填土方量的计算公式。
In this paper, the Galerkin method is used to solve the Laplace-Young equation for calculation of simplified monodisperse emulsion system to obtain the relationship among mean curvature, contact angle, volume fraction, fractional fil...
获得了平均曲率、接触角、体积分数、接触面积分数、单位体积界面积等参数之间的关系，并提出了接触角不为零时的渗透压表达式。
The design needs to dust extraction volume calculation to determine dust masks confined to the size, According to terms of ventilation pipe diameter.
在设计中需要对除尘抽风量进行计算来确定除尘密闭罩的大小，同时根据抽风量计算管道直径。
Development of water to reflect the development of oil field water flooding effect of the six indicators (the use of water reserves, the extent of flooding, moisture content and the relationship between the degree of recovery, water rates, the volume of sweep efficiency, the degree of recovery into a multiple relationship with) the calculation and analysis, to block the development of a water analysis and evaluation, and Type A and Type C water drive curve of the block to predict recoverable reserves.
通过对反映注水开发油田水驱开发效果的六个指标（水驱储量动用程度、含水率与采出程度关系、存水率、体积波及系数、采出程度与注入倍数关系）的计算分析，对区块注水开发进行了分析评价，并通过甲型和丙型水驱曲线对区块可采储量进行预测。
In this thesis, I summarize the theoretical calculation method, applied scope and notice of siphonic drainage system, and point out the advantage of siphonic drainage system compared with gravitation drainage system. In the archetype experiment study of siphonic drainage tube, I adopt different tube diameter and different structural height to survey the drainage volume and press in different place. I observe various kinds of flow state, and get chief factors which influence hydraulic peculiarity of system as the tube diameter or structural height, and find out the relevance of factor to flux. I apply CFD Fluent software and adopt standard k-ε model and RNG k-ε model, then use finite volume method and second-order upwind scheme to discrete numerical model, while coupling numeration of velocity field and press is based on SIMPLE. In the numerical simulation of curved part of tube, siphonic drainage tube experiment system and multi-outlet siphonic drainage system, I make research on internal velocity and press of system in different project condition by changing the tube diameter of curved part, negative press value in tube export and improving the quantity of water gutter. This thesis first adopts a method of combining archetype experiment and numerical simulation to study the siphonic drainage system, test and verify the validity of experiment and numerical simulation, and makefurther study on system, it solves the problems of limited testing conditions, and has a logical results, it can provide a valid method for optimizing and designing the drainage tube-net system. The conclusion have referring value for study and design of siphonic drainage system.
本文首先对虹吸式排水系统理论计算方法、适用范围以及注意事项做出总结，并分析了虹吸式排水系统的优势；再对虹吸式排水管道进行原型试验研究，采用不同管径不同立管高度，对系统流量、管道压强进行量测，观察了各种工况下的流态，对其水力特性进行研究分析，找出影响水力特性的落差、管径主要因素以及与排水量的关系；进一步应用计算流体力学Fluent软件，采用标准κ-ε模型与RNGκ-ε模型，计算过程应用有限体积法和二阶迎风格式对数值模型进行离散，速度和压力的耦合采用SIMPLE算法，分别对系统弯管段、虹吸排水管道试验系统、多斗虹吸式排水系统进行数值模拟分析，通过改变管段弯头处半径、管段出口负压值、增加雨水斗数对不同工况下系统内部的速度和压力进行研究；本文首次采用结合原型试验与数值模拟相结合的方法，对虹吸式屋面雨水排水系统进行研究，试验与模拟相互验证，并进行拓展，很好地解决了虹吸式屋面雨水排水系统由于试验条件限制问题，结果正确合理，为排水管网系统设计和优化研究提供了有效的方法，对工程设计有较好的参考价值。
In this article, to room latent heat load, fan heat gain, duct heat gain, insulation thickness, air temperature and air volume, the choice of cooling coil pipe and end device, has all make a detailed analysis, and provide the concrete calculation instances, which can be the reference for design.
文中对于房间潜热负荷，风机、风管的得热及温升，风管保温要求，送风温度和送风量的确定，冷却盘管的选择计算，以及末端装置的选择等方面都作了详细的分析，希望在设计方法上有所优化。
Analyses the physical characteristics of diesel oil, the volume calculation of daily-use oil tank and the related items in the revised edition of the Code for fire protection design of tall buildings.
摘要对柴油的物理特性、日用油箱的容积计算及修订版《高层民用建筑设计防火规范》相关条款进行了分析。
The complex program complied with C++ programming language, can simplify the calculation of tank volume table s.
用程序设计语言C++编制复杂的油罐容积计算程序，简化容积表的计算。
The grid is generated by Delauney method- A nodal finite volume method is used in the now calculation. The scheme for the nux calculation is vare Leer. The adaptation for the flow computations is mesh enrichment and coarsening.
网格的生成采用Delauney方法，流场的算法为节点型有限体积法，通量的计算采用Vanleer格式，自适应采用网格的增加和删减。
Volume calculation method presented in this paper can computed volume of meshes rapidly and accurately.
所提出的三角网格模型体积计算方法能实现模型体积的快速准确计算。
In addition, the important forms used to calculate the formation parameters, such as shale volume, water saturation and permeability, are improved to be more suitable for the calculation of inhomogeneous formation parameters according to the power law of fract.
将欧氏空间的体积概念在分形空间作适当推广，提出了岩石分形体积模型，并在此基础上推导了岩石分形体积模型的测井响应方程，给出了非均质地层孔隙度的计算方法。
In addition, the important forms used to calculate the formation parameters, such as shale volume, water saturation and permeability, are improved to be more suitable for the calculation of inhomogeneous formation parameters according to the power law of fract...
实际测井资料处理结果表明，用分形测井解释方法计算的地层参数精度比常规方法的高。
In flash calculation, a constant volume flash model is adopted in this paper.
本文在模型闪蒸计算中，引入了适合于动态模拟的定容闪蒸模型算法。
According to a rough calculation, the volume of more than 1000 sets.
据粗略计算，此批货量超过了1000套。