Of bridge could be improved Truss lifting tool adopts for derrick mast hoist that had been made by our unit, readymade member will be lifted and positioned. It is of the feature of simple construction equipment and quick construction progress and a potential of popularization.
桁架部分采用自制的人字扒杆吊机作为吊具，将预制的构件吊起进行悬臂拼装就位，施工设备简单，进度快，具有一定的推广潜力。
As the papers research object is truss structure, a simple life cycle optimization model for it is established.
由于本文的研究对象为桁架结构，因此建立了其优化设计的简单生命周期模型。
Based on a definition of preliminary internal force, a simple computation method of prestressed space truss is put forward in this paper by means of establishing a criterion equation of preliminary internal force.
全部作者：董石麟，邓华发表刊物、期号：建筑结构学报，Vol.22(2)，2001：18-22。论文摘要：本文引入初内力的概念，提出并建立初内力准则方程式来简化分析计算预应力网架结构。
Through analysis of finite element result of 16 roof-truss-frame bracing wall beam according to orthogonal design, a simple formula for calculation of bending moment of section controlled by bridle is obtained by use of Matlab programme of regression.
通过按正交设计的16榀框支墙梁的有限元结果分析，采用Matlab程序回归得出了托梁控制截面弯矩计算的简单公式，可以供设计者参考。
Therefore, they designed and developed a high safety factor, design novel, the assembly of simple, convenient, and has high endurance and suitable to perform various types of truss.
因此，他们设计开发出了安全系数高，造型新颖，装配简单，方便，而且有很高承受力及适合各类型演出的桁架。
The Warren truss is perhaps the most common truss for both simple and continuous trusses.
该特拉斯也许是最常见的桁架既简单又连续桁架。
Simple fuselage based on welded steel truss with D1 sheet from nose to rear of engine compartment, fabric at tail.
简单的机身基础上焊接钢桁架与D1表，从鼻子到尾部发动机舱，在尾部结构。
The fuselage was a simple truss of welded steel tube, with Dl skin as far back as the rear of the engine compartment, where an aft-facing gap allowed fan-induced cooling air to escape.
机身是一个简单的焊接钢管桁架与D1的皮肤，因为早在发动机舱，在那里一船尾，面对差距允许后方风扇引起的冷却空气逸出。
For a guitar equipped with an adjustable truss rod, adjusting the amount of neck bow is quite simple.
准备一个吉他专用的调节棒，调节琴颈的弧度是一个非常简单的事。
It includes the single site damage detection of continuous beam, simple support beam, fixed end beam, overhanging beam, truss, and the multipoint damage detection of simple support beam.
本文采用了连续梁、简支梁、固端梁、悬臂梁、桁架等的单点损伤识别，简支梁的多点损伤识别。
In this paper, a new truss system is designed based on structural systems in use that is used to resist vertical and lateral loads. It is more simple and accurate than other methods available up to date.
笔者在对比借鉴现有结构体系的基础上构思出一种新型桁架体系，用以作为结构的承重体系和横向抗侧体系。与现有结构体系可靠度分析方法相比较，本文方法简单、准确、可行。
Today most simple beam bridges are strengthened by a truss, which is based on the triangle. Initially all structures were prestressed by high-strength bars.
今天，大多数简支梁桥都用三角形的桁架加固。起初，每个桥梁都是通过高强钢筋施加预应力的。
As the paper's research object is truss structure, a simple life cycle optimization model for it is established.
由于本文的研究对象为桁架结构，因此建立了其优化设计的简单生命周期模型。
Effective Lengths of Compressed Members in Multi-planar Tubular Truss with Simple Joints
空间相贯节点钢管桁架中受压杆件的计算长度
A strength formula for the multi-planar joints is suggested. Effective Lengths of Compressed Members in Multi-planar Tubular Truss with Simple Joints
根据试验结果，对空间相贯节点强度计算公式作了初步探讨。空间相贯节点钢管桁架中受压杆件的计算长度
In this paper, a simple and direct method for design of the cross section of the axially loaded compression members and members subjected to combined axial load and bending in steel space truss and reticulated shell structures is given.
本文给出了钢网架和钢网壳结构中轴心受压杆件、拉弯和压弯杆件截面设计的简捷方法，与通常采用的逐次逼近法相比，可避免反复试算，大大减少计算工作量，提高设计效率。
For a complanate parallel chords truss, the axial forces of a member can be solved by the shear-diagram and two simple expressions.
借助与桁架对应的梁的剪力图和弯矩图根据两个关系式可直接求出一般平面平行弦桁架任一根杆件的轴力。
Through the comparison and analysis of the additional force to the jointless track on the steel truss bridge and the simple-supported beam bridge of the same span length, it is found that the structural features of the bridge proper plays a more important role than the temperature span.
通过对同跨度钢桁梁与简支梁桥上无缝线路附加力比较分析，发现桥梁本身的结构特征起着比温度跨度还要重要的作用。
The mechanical property test of the model covering 3 stages under 10 load conditions is carried out to study the loading property of through truss composite beam with simple support.
分3个阶段10种荷载工况进行模型的力学性能试验，研究简支下承式钢桁结合梁桥的受力性能。
Desing and construction of through simple supported beam and welded truss steel bridge with a span of 80 meters
80m跨径下承式简支焊接钢桁架桥的设计与施工