The control objective focuses on the regulation performances of an output vector in response to a stack current command.
控制的目标集中在调整燃处系统输出向的反应。
Plug each force node`s Force output into a Force port on the Add Forces compound. The force`s output is a 3D vector representing the force which is based on the PointPosition attribute of the element.
每一个连接到Add Forces节点端口上的force节点的输出属性都是输出一个三维矢量的数据描述，这都是基于对PointPosition这个属性的作用描述。
The invention is characterized in that: according to the reference ephemeris and the reference vector and the observation vector observed by a star sensor, the spacecraft attitude quaternion can be gotten through Euler-q counting method; through DD2 filter, on one hand, feedback compensation the attitude matrix obtained through resolving by gyro; on the other hand, revise the palstance output of three-axle gyro and conduct compensation to the constant drift of gyroscope.
其特征在于根据参考星历和由星敏感器观测得到的参考矢量和观测矢量，通过Euler-q算法获得航天器姿态四元数，经过DD2滤波，一方面反馈校正陀螺解算获得的姿态阵，另一方面，修正三轴陀螺角速度输出，对陀螺仪的常值漂移进行补偿。
In case of multiple input vectors there should be output vector results.
对于多个输入向量，则输出会是一个向量结果。
In this new algorithm, the weight matrix of the output layer and the output vector of the previous layer are treated as two variable sets. An optimal solution pairis found to minimize the sum square error of the patterns.
在该算法中，输出层的连接权矩阵和前一层的输出矢量被作为 2个变量集合，通过最小化该层样本的总平方误差函数可求得一组它们的优化解；并将 B*p 作为前一层的期望输出，用类似的方法同样可以求出隐层的连接权矩阵和输出矢量。
The main work of this paper is to design a three-stage power amplifier with the center frequency of 880MHz, 10MHz bandwidth, the output power of 40W for CDMA system. The output stage of this amplifier consists of two single-stage amplifiers connected in parallel. We discuss the matching circuit of the output-stage in detailed, then make S parameter simulation and Harmonic Balance simulation using ADS, the result is P1dB=43dBm with very low ports reflection loss. This power amplifier is linearized using feedforward linearization technique. Because of the high requirements of amplitude and phase balance, vector modulator is used to adjust the amplitude and phase balance, and the least power detection method is used to tune the I/Q coefficient of the vector modulator. Considering the adaptive instrument, the RF power amplifier which fulfils the practical requirement is finally designed and simulated.
优化了放大器结构，构造了平衡输出功放结构，详细讨论了相关匹配电路的方案，然后用ADS软件进行了S参数仿真和谐波平衡仿真设计：所得端口反射系数较小，初步设计结果得到不劣于P1dB=43dBm的输出，然后利用前馈技术对初步结果进行线性化处理，针对前馈系统对幅度和相位平衡度要求比较高的情况，有针对性地引入了矢量调制器调整幅度和相位，并用最小功率检测法对所加矢量调制器的I、Q系数进行优化处理，考虑了系统的自适应控制的手段，最终仿真设计出了满足实际需求的射频功率放大器。
Sales Cosme Liuzhou vector inverter and converter with input and output matching reactor, PLC controller, high-low voltage control cabinet, such as complete sets of electrical equipment.
销售科姆龙矢量变频器及变频器配套用输入输出电抗器、PLC控制器、高低压控制柜等成套电气设备。
Outer loop can be designed according to the requirements, current control inner loop can improve dynamic characteristic of the system, for achieve independent dynamic performance of Asynchronous Motor I added output current to the non-linear input voltage as feed forward compensation on base of traditional vector control topology which improve the dynamic-static performance of the system.
外环根据控制目标具体设定，电流控制内环能够改善系统的动态性能，为了得到异步电机动态解耦控制效果，本文在传统矢量控制的基础上，在电流控制环的输出加入了电压的非线性反馈补偿项，使系统的动静态性能得到了进一步提高。
Full sort of the first vector and output that.
全排序第一向量和输出。
In the other part of the thesis, we extend the wideband noise-subspace projection method to the beamforming of the moving source, and the correct steering vector of the moving source can be estimated. Then the estimated steering vector can be used in the adaptive beamforming algorithm to get the optimum output through real time processing.
论文的另一个部份，就是将我们提出的宽频杂讯子空间投影法延伸到可移动信号源的波束成型技术上，透过这个方法可以估出号源在移动后的指引向量，再将估出来的指引向量代入具指向性的波束成型演算法，透过即时处理来找到最佳的输出。
The 8780A vector signal generator'wideband modulation is complemented with an unmodulated coherent carrier output for demodulation of test signals.
该8780a 矢量信号发生器'宽带调制，补充了一个 unmodulated 相干载波输出解调测试信号。
Decoupling control method was adopted to realize both active and reactive power control in the upper layer. The proposed balancing control was applied in the lower layer through adding an active power voltage vector paralleling with output current to the upper output control vector, so active power among homophase chains could be distributed and DC capacitor voltage balance could be achieved.
上层通过解耦控制完成三相链接总的有功和无功控制；下层采用所提出的平衡控制，在上层输出的控制量上叠加一个与输出电流方向平行的有功电压矢量对同相链节间的有功进行分配，实现直流电容电压平衡控制。
The proposed balancing control was applied in the lower layer through adding an active power voltage vector paralleling with output current to the upper output control vector, so active power among homophase chains could be distributed and DC capacitor voltage balance could be achieved.
上层通过解耦控制完成三相链接总的有功和无功控制；下层采用所提出的平衡控制，在上层输出的控制量上叠加一个与输出电流方向平行的有功电压矢量对同相链节间的有功进行分配，实现直流电容电压平衡控制。
A coding scheme is proposed to eliminate the redundancy of output vectors in pyramidal lattice vector quantization.
并证明了，存在唯一的滤波长度为5的对称双正交小波，不存在滤波长度为5的反对称双正交小波。
The other is output vector uncertainties satisfying sliding surface matching condition.
这两个特性是对滑模控制内在优点更进一步的认识。
Analysed above all suit oneself blast output signal, gave out to get used to a directional graph and the relation of the vector that increase advantageous position oneself.
首先分析了自适应阵的输出信号，给出了自适应阵方向图和加权矢量的关系式。
Some theoretical extensions are first made in this paper, with the following concepts, theorems and models presented-Partial derivative and high-order partial derivative of waveform polynomial for describing the relation between input transitions and output transitions and redefining circuit sensitization; The concept of waveform polynomial vector for describing a circuit with multiple inputs and outputs, especially for the unified description of circuit modules; A sensitization theorem for sequential circuits for the purpose of exact timing; Theorems for transition numbers in circuits used to solve problems on noise, power consumption and etc; waveform polynomial description for sequential circuits used to give a unified form for the function and timing behavior of a sequtial circuit; And a data structure of generalized list for the representation and manipulation of waveform polynomial.
波形多项式偏导和高阶偏导的新概念，用来精确描述输出跳变与输入跳变之间的关系，并在本文中用来重新定义了电路的敏化和冒险；波形多项式向量的概念，用于形式化描述实际中的多输入多输出的电路，特别是用于统一描述电路模块的功能及定时行为；时序电路的敏化定理，用于时序电路精确定时分析；波形多项式描述跳变及跳变数的定理，用于噪声、功耗等问题的描述；时序电路的完整波形多项式描述，用于时序电路功能和定时行为的统一描述；波形多项式的多项式符号表示和运算的模型以及数据结构，用来实现对波形多项式比较有效的描述和运算。
With the help of vector analysis, the circuit design criterion for the steady-state deadbeat control to the input currents is put forward. It is useful in obtaining proper circuit parameters to guarantee both the steady-state deadbeat control on the input currents when the AC mains voltage and the load change in a certain range, and the relatively low output voltage which is important in reducing the Miller effect to raise the drive circuit's reliability, and cutting down the voltage stress of all the switches on the DC bus.
采用矢量分析方法推导出基于电压SVPWM的电流稳态无差拍控制的参数设计准则，便于合理设计电路参数，既可以保证在电源电压波动和负载变化的一定范围内实现电流稳态无差拍控制，又可以保持合理的直流侧电压幅值以降低挂在直流母线上的开关器件的电压应力、减小密勒效应以提高驱动电路的可靠性。
The torque fuzzy controller has two inputs (torque error and its change rate) and one output (the torque component of reference voltage vector).
该转矩模糊控制器的输入是转矩误差与转矩误差变化率，输出为参考电压矢量的转矩分量。
In order to solve the stability and accuracy of force feedback output problems, the collision detection and response that based on the OBB tree structure were improved, and then the point of contact location and the vector of contact surface can be returned.
为了解决仿真中力反馈输出的稳定性和准确性问题，本文首先对基于OBB树结构的碰撞检测和响应进行了改进，改进后可以返回接触点位置和接触面的法向量。