The machine is composed of heat stove, blower, oscillating motor and drying case, etc.
本机由热风炉、风机、振动电机、干燥箱等组成。
These conclusions are verified with electromagnetic finite element analysis software, and analytical results prove that they are correct and can be used in designing an air gap for linear synchronous oscillating motor.
最后采用电磁场有限元分析软件验证了得出的结论，结果证明这些结论是正确的，可以在直线同步振动电动机工作气隙设计中采用。
Air gap is one of the important factors which affect the general performances of linear synchronous oscillating motor, thus to seek for a rational shape of air gap is a key point in motor design.
工作气隙是影响直线同步振动电动机工作性能的主要因素之一，寻求合理结构的工作气隙是电动机设计工作中十分重要的内容。
Design of Air Gap for Magnetic Circuit of Linear Oscillating Motor
直线振动电动机磁路工作气隙设计
This paper analyzes the effect of mould lubrication, tundish exchange, mould service life and casting speed on the friction based on the measurement of oscillating motor current.
通过对振动电机电流的测量，分析了结晶器润滑、更换中间罐、结晶器寿命、拉速等因素对摩擦力的影响。
With a series connected capacitor, oscillating will occur in motor winding, the energy stored in capacitor is fed into winding inductance and the current in winding will rise rapidly, thus a relative large output torque is available in high speed.
通过在相绕组中串联电容，使主电路产生振荡，电容储能馈送入绕组电感来快速建立绕组电流，使电机在高速运行时仍有较大输出转矩，达到改善电机矩频特性的目的。
Selecting of AC oscillating motor & its matching invertor
交流振动电机和变频器的选择与匹配
A Speed Tuning System for Triphasic Oscillating Motor with Phase Control Voltage Tuning
三相振动电机相控调压调速系统
Metal Cutting Machine Tool Stimulated Vibration Experiment Innovation of the Oscillating Screen Motor
机床激振实验振动筛激振电机的改造
There are some disadvantages such as oscillating and losing step in traditional open-loop driving control system of three-phase hybrid stepping motor.
传统开环运行的三相混合式步进电动机驱动系统中存在着振荡和失步等不足之处。
The oscillating screen motor is frequently overtired, which has great harm to production and economic benefit.
由于振动筛激振电机烧损频繁，严重影响生产及经济效益；
Innovation of the Oscillating Screen Motor
振动筛激振电机的改造
In order to solve the problem the velocity oscillation of oscillating mirror, permanent magnet synchronous motor (PMSM) was used as a drive motor. System transfer function was established.
为解决摆镜扫描速度振荡的问题，采用永磁同步电机作为扫描驱动电机，建立了控制系统的传递函数模型。
The torch oscillating is implemented through oscillating mechanism driven by servo system controlled by PLC. The roll rotation is completed by the lathe motor controlled by inverter controlled by PLC.
焊炬的摆动是通过PLC控制伺服系统驱动摆动机构实现的；轧辊的转动是PLC通过变频器控制车床电机来完成的：焊炬的移动则是通过PLC控制步进电机实现的。