The memory stop can be set at any position between 0o and 90o of the valve operating stroke.
这种止动记忆可以设置在阀门工作行程0o至90o 角中的任何位置。
Conduct any non-operating checks to ensure instrument operability, that is, remove all shipping stops; check pointer travels; and verify instrument capability to measure, operate, and stroke in the direction and manner required by the process application.
实施各种非运行性检查，以确保仪表的可操作性，即拆除各种运输梏具，检查指针行程，核实其仪表的测量，运行的范围和其被工艺使用时所要求动作行程的方向和方式等 b。
When designing the length of lattice frame, according to the given maximum delivering distance, rational determination of three section booms lengths are required in order to minimize the retracted length so that the longest telescopic stroke, the shortest delivering distance and broadest operating range are obtained.
臂架长度设计时，要求根据给定的最大输送距离，合理设计三节臂架长度，尽量减小完全缩回时的长度，以便取得最大伸缩行程，获得最小输送距离和最大的工作区域面积。
If the equipment moves right and touching EAST switch couldn`t stop the equipment, while touching WEST switch could, immediately stop operating the equipment and exchange the two stroke switch plug and resume the test
如果向 EAST 时，碰 EAST 的不停，而碰 EAST 的停止，立即停止运行设备，将配电箱上两个行程开关的插头调换，重新试验。
Today I have taught you about operating cycle of four-stroke engine in class.
对内燃机来说，空气和燃料的混合是有一定比例的。
For electric operated soft-sealing gate valve, operating torque and stroke of actuator have been adjusted when delivery from factory.
对于电动软密封闸阀，电控装置的扭矩及行程控制出厂时己调节好，不要轻易调整。
A 6 figure, general purpose heavy duty industrial stroke counter designed for high count rates and continuous operation even under the most adverse operating conditions.
6数字，一般用途的重型工业中风柜台设计的高计数率和连续运行，即使在最不利的经营条件。
A great number of dynamometer experiments are carried out to investigate the effects of structure characteristics of the injector, configuration of combustion chamber, design of the bypass valve and fuel injection phasing on the performance, emission, fuel consumption of the engine during light load operating conditions. After a final optimization and other practical considerations, the control MAPs for the two-stroke DISI prototype engine are obtained. The torque performance, fuel consumption and emission economy of the engine is tested and compared with those of the original carbureted engine.
并且通过大量的发动机台架试验，分析了喷油相位和喷油器的结构参数、燃烧室形状、旁通孔的大小等参数对发动机低速低负荷工况下的性能、燃油消耗和排放的影响规律；通过最后的优化和实际的考虑，获得了最终的二冲程直喷发动机样机的控制MAP图，试验研究了其动力性、燃油经济性以及排放性能，还做了该样机和原化油器发动机的动力性能、燃油消耗率和排放性能的比较。
The real stroke of plunger depends on the stroke of polished rod and stroke loss which is resulted from the elastic deformation of flexible sucker rod string and tubing string under load acting, and also depends on the ultra-stroke caused by vibration during operating process of the flexible continuous sucker rod string.
3，柱塞的实际冲程取决于悬点冲程、柔性杆柱和油管在载荷作用下的弹性变形所产生的冲程损失，也取决于柔性杆柱在工作过程中的弹性振动而引起的超冲程。
Valve factory testing, mainly static characteristics of detection, including basic error, rated stroke deviation, hysteresis, the starting point and end point error, dead, repeatability error, sealing, leakage, etc, which are empty make the test cases, in fact they are in the table on the valve to measure the results obtained, but it is difficult to explain the results of the actual operating conditions the valve will show what kind of performance.
调节阀的出厂检测，主要是静态特性的检测，包括基本误差、额定行程偏差、回差、起点和终点偏差、死区、重复性误差、密封性、泄漏性等，这都是在空载的情况下做出的测试，实际上它们是在工作台上对阀进行测量所获得的结果，但这样的结果很难说明阀门在实际运行条件下将会表现出什么样的性能。
Company's main products are: pressure vessel, with a long-stroke pumping unit, oil production wellhead equipment, swimming pulley, packer, tubing anchor, farm trailers, operating Derrick, Derrick Crane, Able to drive me assembly, and other oilfield machinery parts, in May 2001 through the ISO9002 quality system certification.
公司生产的主要产品有：压力容器、带式长冲程抽油机、采油井口装置、游动滑车、封隔器、油管锚、农用挂车、作业井架、井架天车、绞传动箱总成、及其它油田机械配件，于2001年5月通过ISO9002质量体系认证。
The term stroke is used to describe the movement of the iston within the cylinder, as well as the distance of piston travel. Depending on the type of engine the operating cycle may require either two or four strokes to complete. The 4-stroke engine is also called Otto cycle engine, in honor of the German engineer, Dr. Nikolaus Otto, who first applied the principle in 1876. In the 4-stroke engine, four strokes of the piston in the cylinder are required to complete one full operating cycle. Each stroke is named after the action it performs intake, compression, power, and exhaust in that order
术语冲程是用来说明活塞在气缸内的运动，也就是活塞行程的距离根据发动机类型的需要二冲程或四冲程来完成一个工作循环四冲程发动机也叫做奥托发动机，为了纪念德国工程师奥托，他是在1876年第一个应用该原理的，在四冲程发动机中，要求气缸活塞四冲程来完成一个完整的工作循环，每个冲程根据其行为命名分别为：进气冲程，压缩冲程，作功冲程和排气冲程。
Originally it was the safety valve for a hydraulic plant. For electric operated soft-sealing gate valve, operating torque and stroke of actuator have been adjusted when delivery from factory. Don't adjust once again rashly.
它最早是一家水电厂的安全闸阀。对于电动软密封闸阀，电控装置的扭矩及行程控制出厂时己调节好，不要轻易调整。
When working on lightning and rainy days, the operating personnel is likely to be hit by lightning stroke and unexpected casualty may be caused.
操作人员在雷雨天气工作时，有可能遭雷击，造成意外伤亡事故。
This experiment utilized a single-cylinder four-stroke diesel engine generator to set up the test bench of diesel engine lubricant usability performance. Furthermore, complete the design of the test scheme including operating schedule and the rule of taking oil samples.
本文考虑到试验的重复性及真实性，选择利用单缸四冲程柴油发电机组搭建柴油机润滑油使用性能的试验台架。此外，本文设定了包括运行程序、取油规则在内的具体试验方案。
Analysis of Correlation and Receiver Operating Characteristic Curve on Stroke Acute Stage Syndrome and Serum C-reactive Protein
中风急性期证候与血清CRP的相关性及ROC曲线分析
In the4-stroke engine, four strokes of the piston in the cylinder are required to complete one full operating cycle.
在四冲程发动机，四冲程汽缸中的活塞需要完成一个工作循环。
The 2-D flow-arc model is solved combined with opening characteristics of driving mechanism by analogous computation, then the operating performance of driving mechanism, the dynamic properties of arc and flow field in every stroke location during breaking period are revealed.
在一定近似条件下将灭弧室的气动特性与操动机构的操动特性进行了联合模拟计算，可以得到在各个时刻、各个行程点处操作机构的运动特性及灭弧室内气流场、电弧的动态特性。
A 5 figure, rugged stroke counter, with right-hand shaft extension, operating lever and attached spring.
5数字，坚固耐用的中风柜台，与右手轴延伸，操纵杆和所附的春天。
It has been recently upgraded to provide excellent cleanliness and load carrying in the latest high output long stroke engines, even operating at 100% load in power plant duty.
经过近期的改进，该产品现具有极佳的清洁度和负载能力，可用于最新高输出长冲程引擎，甚至可在电厂应用中以100％负载率进行操作。