Step-scan amplitude modulation technique on FTIR has been built and applied to the measurement of electroluminescence spectra of Ga-doped germanium at cryogenic temperature. We found emission lines with maxima at ~2.01 THz (67.0 cm-1) and at ~2.60 THz (86.7 cm-1), corresponding to the radiative transitions of holes from the excited impurity states to the ground state of impurity center. The line at 2.60 THz was observed for the first time and investigated.
使用傅立叶转换红外线频谱仪的步进扫描振幅调变技术来纪录在外加脉冲电场下的锗掺杂镓样品於低温之兆赫波放射频谱，观察到受电场激发的电洞从杂质激发态辐射跃迁至杂质最低能阶，放出2.01 THz (67.0 cm-1)和2.60 THz (86.7 cm-1)的兆赫波光子，而且我们是第一次量测到锗掺杂镓的2.60 THz放射谱线的实验团队。
Further, a cathode voltage line and a scan driver each may include an edge part formed in an obtuse angle.
进一步地，阴极电压线以及扫描驱动器的每一个都可以包括形成钝角的边缘部分。
This paper analyzes the minimal build mechanism in line scan conversion and presents a new scan algorithm.
深入研究了直线扫描转换的最小生成机制，提出一种扫描转化算法。
Mark'.''to the next so that a new line of characters is visible to the scan head.
标'。''移到下一个，以使扫描头可读取一个新的字符行。
To anticipate these moves you will need good vision patterns. Glance up and scan from the trial horizon back to your wheel for obstacles turns; terrain changes and shifting spots, check the line of your front wheel and look beyond to the next move.
要估算前进路线需要建立好的观察模式，在路径和前轮之间水平来回扫描观察，包括障碍物、弯道、地形变化、转折点，找出前轮的动线并关照下一个应变。
The CCD camera is dragged by a step motor to achieve line by line scan of tapered thread projection.
电压耦合元件照相机被一个步骤马达拖拉达成逐渐变小的线发射的线扫描的线。
With the nonlinearity of bi-directional mirror scan, motion of spacecraft and attitude variability, the model of the line of sight and Projection for Landsat 7 are very complex, and it cost much time during systematically geometric correction.
Landsat7采用双向扫描的方式，由于扫描非线性及卫星姿态和轨道的波动，使得建立卫星视线的计算量增大。
Abstract］ objective the significance and reason of multi-lines of interlobar fissure revealing on mip reconstruction imaging in multi-row ct scanning was approached. methods general data:sixty-six normal subjects selected from ct examination were taken into axial mip reconstruction. there were 39 males and 27 females, average age was 30.5 （from 16 to 76）.checking method:ge lightspeed vct, scan parameter:120 kv, 89～301 ma, rotation speed 0.6 s/r, table moving 55 mm/r, pitch 1.375, slice thickness 1.25 mm. window width 1000 hu and window level -700 hu were applied. then the images of slice of 1.25 mm were input into the list of mutil-plannar reformation in the workstation, the edition of aw 4.3.the thickness of mip reconstruction was 6.2 mm. results the pulmonary fissure was becoming more lines while slice thickness of axial mip reconstruction from 1.2 mm increased gradually. interlobar fissure showed five clear lines when the slice thickness of mip became 6.2 mm, resembling staff sign. wide line type and fine line type can be divided according to the shape of interlobar fissures on mip. conclusion there would be some help that the staff-like sign discriminate accessory fissure from other lines in the lung.
目的 探讨叶间裂在多排螺旋ct扫描 mip重建图像上展现呈多根线条状影的形成原因及意义。方法从110例胸部ct扫描报告正常者中，挑选健康体检者或临床无咳嗽等呼吸道症状，因外伤、胸痛、身体不适等66例做轴位mip重建。检查方法：ge lightspeed vct，扫描参数：120 kv，89～301 ma，旋转速度0.6 s/r，床移动55 mm/r，螺距1.375，层厚1.25 mm。观察图像窗宽1000 hu，窗位-700 hu。将1.25 mm层厚图像输入工作站做多平面重建。工作站版本aw 4.3.mip重建厚度6.2 mm （或6.3 mm）。结果轴位mip重建时，层厚从1.2 mm（或1.3 mm）开始，逐步往上调节，随着层面厚度增加，叶间裂从单一线条变成多根线条。在mip厚度标识上，每点击左键一次，厚度增加一次，线条增加2条，至6.2 mm（或6.3 mm）时，叶间裂展示呈五根清晰线条，似五线谱样。根据叶间裂在mip重建图像的形态，可分为粗条型和纤细型两类。结论叶间裂五线谱样表现对鉴别副裂与肺内其他结构有一定的帮助。肺；胸膜；图像处理，计算机辅助；体层摄影术，x线计算机
When scanning, from light transmitter beams shines on the bar code on the basis of the photoelectric detector from bar code on the binvalidation of the reflected light intensity to respond to that, when scanning a white spot sweep to the surface or in two in the space between the black line, the reflection of light intensity, high current output a detector; when the scan-to-black lines, reflected light, detector output UN-effectual, on the basis of narrow-striped width or length of time made in response to changes in light and shade with bar code and converted to a little different current signal, after a post to the bezze codec.
扫描时，从平发射器发不入的平束照在条码上时，平电检测器根据平束从条形码上不直射返来的平不不弱度息不入回答，当扫描平不背扫到白纸背上或处于两条暗线之间的空缺处时，不直射平不不弱，检测器输不入一个不小电流；当扫描至暗线条洋时，不直射平不弱，检测器输不入小电流，并根据暗线宽或广息不入工夫不幼短差别的反响，随着条形码明暗的改变变化为人小差别的电流暗记，经过放不小后运输到泽码器洋去。
This last line is the one you`ll need to scan for and patch.
这最后一行就是你要去搜索和进行修改的。
The distance between the X-ray dye column and the line of uncovertebral joints averaged 4.7 mm in the left and 4.2 mm in the right. While the distance from the borderline of the gutter to vertebral arteries with CT scan averaged 6.1 mm in the left and 5.9 mm in the right. The measured distance by radiographic technique underestimated the true distance.
结果造影剂距钩椎关节连线的平均距离左侧4.7 mm，右侧4.2 mm，CT扫描显示减压边缘距横突孔内侧壁的平均距离左侧 6.1 mm，右侧5.9 mm，X线造影所测得的距离均小于CT所测得的实际距离。
A fast scan line algorithm for removing hidden surface based on Watkins algorithm is presented, and how to perform realism in FSL algorithm is described.
本文在Watkins算法的基础上，提出了隐藏面消除的快速扫描线算法，且给出了在FSL算法中图形真实感的处理算法。
A slow mirror scanner (13) is arranged to scan consecutive line images to form a two-dimensional image.
慢速反射镜扫描器(13)设置为扫描连续的线图像以形成二维图像。
Edge detection based on the value of the second scan line and a combination of license plate location method.
详细说明：提出了基于边缘检测的二值化与扫描线相结合的车牌定位方法。
A method of filling arbitrary polygon which is based on scan line and seed filling is proposed.
提出一种扫描线与种子填充相融合的多边形填充算法。
In the main loop, once an input line has been read into buf, it is passed to scan, which for each call places the next input symbol into the variable token.
2 扫描仪在主循环中，一旦输入数据被传入buf，它就会传递至scan函数，为每一处调用函数的地方提供下一个输入变量标志。
The QuickFill algorithm is a non-recursive method of filling a 2D graphics image using a scan line search method and doubly linked to lists of nodes to reduce the amount of memory required.
该QuickFill算法是一种非递归填补一个2D图形图像使用扫描线搜索方法和双向链表的节点的清单，以减少所需内存量的方法。
Line scan circuit failure is caused by no power on display raster display without an important reason.
行扫描电路出现故障是引起显示器加电后无光栅无屏幕显示的重要原因。
Moreover, the PEM images and line-scan results such as profile of the photocurrent obtained before, during and after pitting corrosion can also provide the information concerning the accumulation and diffusion of the corrosion products in the corrosion site.
另外在点蚀前后及孕育期中得到的PEM图象和线扫描结果所反映出的局部光电流的变化（如光电流峰的形状、大小等）在一定程度上反映了钝化膜局部区域腐蚀产物富集与扩散特征。
In order to realize precise compression of scattered data and predigest the establishing process of geometry topology relation, scattered data is converted into scan line data, the point cloud is disposed by the method of direct slicing, the algorithm of intersection between line and surface based on a pair of the least distance relation points and the algorithm of track based on eight directions coding of the section contour data are carried out and the method feasibility is proved by the example.
为了实现数据的精确压缩，简化点与点之间拓扑结构的建立，把散乱数据转化为扫描线数据，对点云数据进行了直接分层处理，采用了基于最小距离关联点对的线面截交算法和截面轮廓数据的八方向编码追踪算法，并用实例验证了方法的可行性。