The principle of combustion of flat oil flame with low-pressure atomizing air has been studied here and so a relevant oil burner has been developed.
在理论分析的基础上，提出了在低压雾化条件下实现重油平火焰燃烧的原理，并研制了相应的新型油烧咀。
Refer to the German technologies, they have designed and made up the flame scaling furnace which uses the YP type flat flame burner, avoid the super heat in local position and prolong the service life of the iron pot.
参考德国技术设计制造的使用YP型平焰烧嘴热浸镀锌炉，避免了局部过热，延长了锌锅使用寿命。
My factory production burner, press the fuel used in high and low calorific value gas as follows: liquefied petroleum gas, natural gas, coke oven gas, mixed gas, producer gas, blast furnace gas, etc.; separately by flame characteristics as follows: high-speed burner thermostat, flat flame burner, direct flame burner, etc.; burner from the combustion capacity of 10 standard m 3 per hour to below 6000 m 3 over a wide range of standard specifications.
我厂生产的烧嘴中，按燃用的燃气热值高低依次为：液化石油气、天然气、焦炉煤气、混合煤气、发生炉煤气、高炉煤气等；按火焰特征分别为：高速调温烧嘴、扁焰烧嘴、直焰烧嘴等；烧嘴的燃烧能力从每小时10标米 3 以下至6000标米 3 以上多种规格。
Because of the shape of the burner block, the flat flame will directly radiate to the load.
因为炉头砖的形状，平焰会直接辐射到加热体上。
A flat flame burner, specially designed burner for delay coker heater, was investigated by numerical simulation.
对延迟焦化加热炉用扁平火焰燃烧器进行了数值模拟研究，通过数值模拟分析了不同燃料情况下燃烧器的速度场和温度场。
The optimum construction and p-V characteristic curve of air and gas have been obtained by the 1:1 cold and hot test for designing of WQ-10 flat flame gas burner.
通过对WQ-10型煤气平焰烧嘴进行各种关键尺寸的1：1冷态和热态试验，确定了合理的结构尺寸，并获得了空气和煤气p-V特性曲线。
Study on semi-industrial experiments for type WQ-10 gas flat flame burner
WQ-10型煤气平焰烧嘴的半工业性试验研究
Study on flat flame burner (mpy) for pulverized coal
MPY型煤粉平焰烧嘴的研究
Application of Twin Whirl Flat Flame Burner in Muffle Type Wire Heat Treatment Furnace
双涡双旋平焰烧嘴在钢丝热处理马弗炉上的应用
Development and application of new double rotational flow flat flame burner
新型双旋流平焰烧嘴的研制与应用
In view of the heat transfer characteristic of furnace that flat flame burner was installed in its top, heat transfer was simulatively calculated by Zonemethod.
针对炉顶平焰供热炉的传热特性，采用区域法对炉膛内的传热进行了模拟计算。
Experimental study on heat state of burner nozzle with 200m ￣ 3/h gas flat flame
200m~3／h煤气平焰烧嘴的热态试验研究
The design idea and construction parameters and industrical trial results of a new double rotational flow flat flame burner are shown ill this paper.
介绍了一种新型双族流平焰烧嘴的设计思路、结构参数及工业试验结果。
Numerical simulation studies of flat flame burner
扁平火焰燃烧器数值模拟
Flame Scaling Furnace Attached by YP Type Oil fired Flat Flame Burner
使用YP型燃油平焰烧嘴的热浸镀锌炉
To study the dominant mechanism of combustion speed field under flat-flame burner infurnac eprocess, a cold model was established by similarity and modeling theory (1 ∶ 1);
为研究加热炉平焰旋流烧嘴下方燃烧速度场的主要机理，采用相似和模化理论建立了冷态实验模型（1∶1）；